316L stainless steel decorative tube

316L stainless steel decorative pipe in the factory is 3 kinds of cross section shape: round pipe, square pipe, rectangular pipe, are bright surface, but for the thickness will have a certain requirement, do you know why? Next Xiaobian for everyone to analyze.

We usually see stainless steel pipe wire drawing pipe, oval type and other shaped pipe, is made of reprocessing. In addition, when the stainless steel decorative pipe leaves the factory, it is a straight pipe of 6 meters, and those stainless steel decorative pipes of various lengths and various shapes are also made of post-processing.

Processing stainless steel decorative pipe generally have thickness requirements, once a customer took a lot of φ63mm*0.7mm 201 stainless steel decorative pipe, to our factory for surface drawing processing, the worker did not figure out the thickness of the material directly to the wire drawing machine processing, the machine just started soon, found the surface of the material black, like scorched, This stainless steel pipe is scrapped.

The wire drawing machine uses two sets of impeller before and after to clamp the stainless steel decorative pipe to push forward the surface of the wire drawing, too thin stainless steel pipe due to the surface elasticity is too large, the surface of the impeller is easy to burn out, so the thickness of the stainless steel decorative pipe is required when the surface treatment.

The same stainless steel decorative pipe in the process of bending, it is also easy to appear the phenomenon of surface cracking or wrinkling, such as clothing props factory commonly used φ25mm right Angle bending circle, 0.9mm thickness bending out of the right Angle effect is the best, less than 0.9mm thickness processing surface is easy to crack, wrinkle.

For the consideration of material cost, when customers need us to process, the choice of materials is of course the thinner the better, but the effect of too thin stainless steel pipe decoration pipe processing can not meet the requirements of customers, at this time we will give customers the most reasonable advice.